Indiana’s aviation mix — from Indianapolis International to military airports and the Purdue University aviation program — creates a patchwork of controlled airspace that requires careful preflight planning. Use the interactive map below to check UASFM altitude authorizations, controlled airspace classes, FRIA zones, club flying sites, and airport locations across Indiana.
Understanding the drone airspace map for Indiana
The color-coded UASFM grid shows the maximum altitude in feet above ground level (AGL) at which a drone operator may fly under LAANC authorization in each grid cell. Cells shaded red indicate areas with a 0 ft ceiling where manual FAA DroneZone authorization is required. Cells shading from orange to dark green represent increasing authorized ceilings up to 400 ft AGL. In airspace not covered by the UASFM grid, the standard recreational rule of 400 ft AGL applies in uncontrolled Class G airspace.
Controlled airspace in Indiana
Indianapolis International (IND) has Class C airspace. Evansville Regional (EVV), Fort Wayne (FWA), and South Bend (SBN) have Class C or D airspace. Grissom ARB creates restricted military airspace in north-central Indiana. Toggle the Airspace Classes (B/C/D) layer on the map to overlay boundary outlines: solid blue for Class B, solid magenta for Class C, and dashed purple for Class D. Class B airspace requires authorization at all altitudes. Class D airspace is active only during tower operating hours and reverts to Class G after hours.
FRIA zones and club flying sites in Indiana
FAA-Recognized Identification Areas (FRIAs) are designated zones where approved recreational pilots can fly without Remote ID broadcast equipment. Toggle the FRIA Zones layer to see established sites across Indiana, and the Club Flying Sites layer to find AMA-recognized flying fields near your intended location. Always verify current site status with the sponsoring organization before flying.
Using LAANC in Indiana
LAANC (Low Altitude Authorization and Notification Capability) provides near-instant airspace authorization through FAA-approved apps such as Aloft, DroneLink, and Kittyhawk. Where a UASFM grid cell shows an altitude above zero, operators can request authorization up to that ceiling. Grid cells showing 0 ft require manual authorization through FAA DroneZone — a process that typically takes up to 90 days. Click any grid cell on the map to see its ceiling altitude and LAANC availability.
Indiana drone laws and local restrictions
Indiana Code 8-21-12 regulates drone operations statewide, establishing civil liability for privacy violations and prohibiting flights over correctional facilities. The map shows federal airspace data only — local no-fly zones set by cities, counties, or state agencies are not depicted. Always verify current regulations at FAA.GOV/UAS before every flight.
Drone maps for neighboring states
Explore drone airspace in states near Indiana:
- Illinois Drone Map
- Kentucky Drone Map
- Michigan Drone Map
- Ohio Drone Map
- US Drone No-Fly Zone Map — full nationwide view with all controls
More drone and map resources
- US Airports Map — find airports, runways, and airfields nationwide
- KML Circle Generator — draw radius buffers for flight planning and site assessment
- US Power Plants Map — locate energy infrastructure to avoid in your flight path




























